Aluminum gutters are a great product. They don’t rust, are available in popular colors, and can be shaped quite easily. Aluminum rain gutters have been around for 30+ years.
Aluminum gutters also have the advantages of being lightweight and relatively easy to work with. They are weather-resistant across the board and maintain their integrity in cold climates.
We have the outlet tubes to fit all the different gutter and downspout sizes.
Gutter Hangers are the brackets that give the gutter its strength and support. The type of gutter bracket and its spacing will largely determine the longevity of any gutter system.
K Style Mini Hangers are made with .060 gauge heavy duty aluminum, our new Mini Hanger is one of the strongest hangers on the market.
Quick Screw Gutter Hangers are manufactured with the screw in place and ready to go.
OUTER CORNER STRIP MITER
INNER CORNER strip MITER
Inside Strip Miters require the two adjoining gutters to be cut on 45 degree angles. Strip miters are preferred by contractors who only want one seam per corner. Good for 90 degree corners.
outside box miter
- Outside Box Miters are the corner pieces made up of two pieces of gutter that are seamed together. These are the contractor favorite because they look good and are fast and easy to install. Good for 90 degree corners.
Outside Box miters should be riveted to the gutters.
INNER CORNER BOX
Inside Box Miters are the corner pieces made up of two pieces of gutter that are seamed together. These are the contractor favorite because they look good and are fast and easy to install. Good for 90 degree corners.
Box miters should be riveted to the gutters and sealed with 12-1 sealant.Available in aluminum
The Rectangular Downspout is a pipe for conveying rain water from a roof or gutter to the ground or to a drain.
Also referred to as Leaderpipe, Downpipe, or Drainspout.
Rectangular Downspouts typically accompanys K Style Gutters..
Two (2) Pipe Clips are required for every 10 feet of downspout.
Three (3) Pipe Clips are sufficient for a straight 20 foot run.
For a 10 foot run, place (1) approximately 1 foot from the bottom and (1) one foot from the top.
For a 20 foot run, place (1) approximately one foot from the bottom, (1) in the middle and (1) one foot from the top.
Sometimes called smooth round, plain round refers to the round downspouts and elbows that don’t have any corrugations. Each round elbow comes crimped, in order to fit inside other downspouts and elbows. The non crimped end easily fits over the outside of the half round outlet tube.
A K Style End Cap is the fitting that attaches to and closes off the end of the gutter. This particular end cap is sometimes referred to as the Crimp On End Cap.
Installation of an End Cap
The crimp on end cap is the contractor standard and is the easiest and fastest to install on to the gutter. It requires the use of a hand tool called the end cap crimper. This installation does not require any fasteners.
Bring the horses! This lovely 10-acre farm offers options for gardening, small livestock and everything country living has to offer. With 5 bedrooms and 3 baths, it has great B&B potential.